Below you will find some links to difference resources I used in gathering the data needed for the project.
Setting up the stepper motors for the Duet and calculating settings.
https://forum.duet3d.com/topic/5843/anet-a8-stepper-motor-question?_=1575204578629
https://zalophusdokdo.github.io/StepperMotorsCalculator/en/index.html
https://3dprint.wiki/reprap/anet/a8/steppermotor
How to figure out and setup your steps per mm.
https://3dprinterwiki.info/extruder-steps/
Configuration
https://forum.duet3d.com/topic/8410/rrf-config-tool-template-for-anet-a8/3?_=1575204146597
https://configtool.reprapfirmware.org/Start
Wiring the QuadFusion to the Duet: NOTE: for the fans use the two middle 5v ports! DON’T use the Always on port as it is 24v and will burn up your tool fan. Keep in mind these are for the Quad Crane however the systems I installed are the same as the Quad Crane.
https://github.com/PrintM3D/Quad-Fusion-Docs/blob/master/supported-printers/duet-maestro-wiring.md
https://quadfusion.printm3d.com/supported-printers/m3d-crane
QuadFusion Documentation
https://quadfusion.printm3d.com/